Heidenhain TNC 640 (34059x-04) Cycle programming Instrukcja Użytkownika Pobierz pdf (Strona 407)

100

101

Before You Start Working with Touch Probe Cycles 14.2

TNC 640 | User's Manual Cycle Programming | 3/2014

407

14.2 Before You Start Working with Touch

Probe Cycles

To make it possible to cover the widest possible range of

applications, machine parameters enable you to determine the

behavior common to all touch probe cycles.

Maximum traverse to touch point: DIST in touch probe

table

If the stylus is not deflected within the path defined in DIST, the

TNC outputs an error message.

Set-up clearance to touch point: SET_UP in touch

probe table

In SET_UP you define how far from the defined (or calculated)

touch point the TNC is to pre-position the touch probe. The smaller

the value you enter, the more exactly you must define the touch

point position. In many touch probe cycles you can also define a

set-up clearance that is added to SET_UP.

Orient the infrared touch probe to the programmed

probe direction: TRACK in touch probe table

To increase measuring accuracy, you can use TRACK = ON to

have an infrared touch probe oriented in the programmed probe

direction before every probe process. In this way the stylus is

always deflected in the same direction.

If you change TRACK = ON, you must recalibrate the

touch probe.

1 2 ... 402 403 404 405 406 407 408 409 410 411 412 ... 602 603

Komentarze do niniejszej Instrukcji

Brak uwag

Heidenhain TNC 640 (34059x-04) Cycle programming Instrukcja Użytkownika Strona 407

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Ekwipunek Heidenhain TNC 640 (34059x-04) Cycle programming