Heidenhain TNC 620 (34056x-04) Cycle programming Instrukcja Użytkownika Strona 450

  • Pobierz
  • Dodaj do moich podręczników
  • Drukuj
  • Strona
    / 468
  • Spis treści
  • BOOKMARKI
  • Oceniono. / 5. Na podstawie oceny klientów
Przeglądanie stron 449
Touch Probe Cycles: Automatic Tool Measurement
19.1 Fundamentals
19
450
TNC 620 | User's Manual Cycle Programming | 5/2013
Entries in the tool table TOOL.T
Abbr. Inputs Dialog
CUT
Number of teeth (20 teeth maximum)
Number of teeth?
LTOL
Permissible deviation from tool length L for wear
detection. If the entered value is exceeded, the TNC
locks the tool (status L). Input range: 0 to 0.9999 mm
Wear tolerance: length?
RTOL
Permissible deviation from tool radius R for wear
detection. If the entered value is exceeded, the TNC
locks the tool (status L). Input range: 0 to 0.9999 mm
Wear tolerance: radius?
DIRECT.
Cutting direction of the tool for measuring the tool during
rotation
Cutting direction (M3 = –)?
R_OFFS
Tool length measurement: Tool offset between stylus
center and tool center. Default setting: No value entered
(offset = tool radius)
Tool offset: radius?
L_OFFS
Tool radius measurement: tool offset in addition to
offsetToolAxis between upper surface of stylus and
lower surface of tool. Default: 0
Tool offset: length?
LBREAK
Permissible deviation from tool length L for breakage
detection. If the entered value is exceeded, the TNC
locks the tool (status L). Input range: 0 to 0.9999 mm
Breakage tolerance: length?
RBREAK
Permissible deviation from tool radius R for breakage
detection. If the entered value is exceeded, the TNC
locks the tool (status L). Input range: 0 to 0.9999 mm
Breakage tolerance: radius?
Przeglądanie stron 449
1 2 ... 445 446 447 448 449 450 451 452 453 454 455 ... 467 468

Komentarze do niniejszej Instrukcji

Brak uwag